login
The UK's LARGEST Online Resin Superstore

Trouble Shooting

Sedimentation: Mix material until homogenous before use
Soft or sticky areas: Poor mixing
Streaks in surface: Poor mixing or casting too warm
Crystallisation (1): Low storage temperature
Crystallisation (2): Material beyond shelf life
Material softer or harder than normal: Check mix ratio
Slow cure speed: Warm gently
Fast cure speed: Cool gently or add filler
Excessive shrinkage: Cast material in several hits
Leaking Containers or packaging: Do not use. Ask for replacement
Excessive bubbles or air entrapment: Evacuate material or pour warm
Material is too viscous: warm material gently before mixing
Mould leaks material: Seal with latex mask
Material sticks in mould: use release spray
VAT Number: GB 194 4985 09

Registered Office: Robnor Resins Ltd, Hunts Rise, South Marston Park, Swindon, Wiltshire. SN3 4TE UK
Registered No: 664718

© 2017 Resins Online. VAT Reg. No. 194 4985 09 | Privacy Policy | Cookie Policy | Sitemap | Site credits

brand logos